A little while back, I was contacted by a customer who was
looking for a way to clean chips and debris out of tapped holes in an
engine block. They were familiar with our products, having used them in
several different areas in their plant, and had done some early research
into our Air Nozzles.
They were considering using our small M4 Back Blow Air
Nozzle in the process. The Back Blow Air
Nozzles produce a 360° airflow that blows away from the end
of the nozzle and in many cases, are the ideal solution
for treating the inside diameter of hose, pipe, machined holes,
etc. These unique nozzles, eliminate the concern of forcing particulate
further down into a machined hole or the safety issue of blowing material
out of the opposite end of an open tube or pipe.
EXAIR
Back Blow Air Nozzles come in three sizes, for bores from 1/4" to
16" in diameter!
In this particular case, having the material blown out of
the hole increased the risk of possible cross contamination somewhere else
in the engine block so they were also thinking of incorporating some type
of recovery system like our Chip Vac or one of our Line
Vacs but were concerned with having to use two separate
devices.
Once again, EXAIR has the perfect solution, the Deep
Hole Vac-u-Gun. The Deep Hole Vac-u-Gun features a
small blow tube (1/8" OD) that provides a small blast of air to
dislodge or loosen foreign material while simultaneously providing vacuum
to carry the debris away.
If you have a similar application or would like to discuss
how an EXAIR Intelligent Compressed Air
Product can help solve a unique situation, contact an
application engineer for assistance.
Comentários
Enviar um comentário